HM 10-500K

Crane fed chipper on single or tandem axle chassis, with or without crane Feed: - Pressure roller with steel teeth (Ø 800 mm) - Conveyor belt 900 mm long - In-feed table 1.500 mm long Feed Flap: - Hydraulically foldable - Front end roller at the in-feed table - Optional infeed conveyor belt Sieve: Standard Mesh 45/60mm Drum Ø: 495 mm with quick change blades Flywheel: 1.000 kg Ejector: - Hydraulically foldable, adjustable for height and rotatable (Ejecting height approx. 3.35 m up to 4.25 m; depending on chassis and tyres) - Hydraulic ejector flap adjustment Controls: - Automatic load-dependent feed controls - Two day counters and one overall operating hours counter - Feed speed infinitely variable - Feed direction reversible - Remote Control with 10 m cable and control panel for all functions Drive: PTO shaft and V belt transmission Drive rpm: max. 1.000 min-1 Drive Power: max. permissible 170 KW / 230 PS Chassis options:

Chassis 40/60km/h Factory tandem axle with air brakes Tyres: 385/55 R22.5 up to 80 km/h, Road tyres 400/55 R22.5 up to 40 km/h, Off-road tyres 560/45 R22.5 up to 40 km/h; Off-road tyres The Powered In-feed table allows better transfer of wood into the chipper particularly short pieces or brash. Also due to small gap between powered In-feed table and the lower in-feed bed dirt and small debris can fall through. We can mount a standard agricultural pick-up hitch to the rear of a chipper for standard UK pick-up hitch trailers. Operation is via the main chipper control panel and changeover switch. We build special application chassis with options for higher road speed and better ground clearance and travel over soft ground. We have designed and built several bespoke chassis for these chippers incorporating kronos cranes along with other options such as crane mounted cabin.