HIGHLIGHTS

With the HEIZOHACK wood chipping machines wood waste, such as slats, beams, logs, blocks and branches and whole tree trunks with a diameter of up to 30cm (300 series) and up to 40cm (400 series) can be shredded with little energy required. A steel conveyor belt and a pressue roller with welded tongs ensure powerful and reliable feeding of the chipping material.

HM 4/6 -300

The manually fed wood chippers for mobile and flexible operation on the spot. The chipper is transported on a trailing axle or the three point hitch of the tractor.

The HEIZOHACK feed control HE 002 controls the feed motion of the wood to be made into chips irrespective of the drive performance.

The integrated operating hours counter stores the daily and total numbers of hours. Auto reverse is available for the stress control to clear the drum.

Also available with an electric motor or a diesel engine and its own Chassis (HM6-300VM)

SPECIFICATION

Feed in:

  • Conveyor belt 600mm long6-300
  • In-feed table 900mm long
  • Pressure roller with steel teeth 380mm

















Sieve

  • Standard mesh 35/40mm

Chip Drum

  • 450mm with quick change blades

Drive Performance

  • Power take-off shaft
  • Max speed 750 rpm

Flywheel

  • 1120mm 
  • 60mm thick

Discharge Chute

  • Manually foldabale and rotatable6-300-1
  • Supported by pneumatic shock damper








































Controls

  • Automatic load-dependent RPM control of the feed with two daily hours counters and an overall operating hours counter
  • Belt and roller speeds infinitely adjustable

Chassis

  • Chassis 25 km/h unbraked and trailing axle
  • Chassis 25 km/h with cable brake and trailing axle
  • Tyres - 10/75 - 15.3


Pressure Assist

ACP Pressure Assist – This is a self contained hydraulically
actuated system that allows a pre-set and limited pressure 8-400PressureAssist
to the top feed roller assembley, this makes the in-feed far 
more aggressive and is recommended where difficult forked timber 
and brash, spruce is to be chipped. Control via pushbutton or radio control.



8-400PressureAssist-1        8-400PressureAssistRC









F.A.Q'S

Can I machine feed this chipper?

These chippers are for hand feeding only.

How much will it Chip?

The amount of chip produced is down to how much timber can be physically chipped by hand.

Are they easy to maintain?

The sieves and blades are easy to change, the blades cost around £10.00 each.


What size of tractor do I need?

They require a minimum of 100hp, up to 130hp.

How much will it chip?

The amount of chip produced is down to how much timber can be physically chipped by hand!

Are they easy to maintain?

The sieves and blades are easy to change, the blades cost around £10.00 each.























































Follow Us: